Faster dedicated measuring fixtures
Measuring fixtures cannot always be assembled exclusively from standard components. When complicated part geometry and/or special contact situations are involved custom-built workpiece adaptations are needed.
Usually Witte Bleckede, manufacturer of modular fixturing system Alufix, supplies such custom-built components conventionally milled. In order to speed up manufacture of special parts Witte is taking advantage of rapid prototyping possibilities and utilizing RapidFit from Materialise.
Pre-design of fixtures using standard components as far as the contact points takes place with Witte design software "Alufix Expert” then RapidFit takes care of the custom-built part supports. The geometry for the supports is calculated via Alufix Expert data. They are then materialised by laser sinter technology from a powdered basic material (thermoplastics) layer by layer. Arbitrary three-dimensional geometry can be produced, which often cannot be manufactured by conventional mechanical manufacturing processes.
Thus even extremely complicated contour parts are available within a short time. If part changes occur only the special laser-sintered parts need be exchanged, and they are redesigned, supplied and mounted very quickly.
Photo RapidFit 1:
RapidFit part as a gauge fixed on Alufix profil
Photo RapidFit 2:
Alufix – RapidFit fixture holding a sheetmetal beam
Photo RapidFit 3:
RapidFit parts connected via Alufix components on an Aluquick fixture
